Kyocera Mita FS-6750, Руководство по обслуживанию, Страница: 126 / 161

Troubleshooting
General error handling
6-6 FS-6750
6.3 General error handling
Maintenance messages
Table 6. 4
Message Corrective action
(paper source)
The paper has run out. Supply paper according to the paper
source displayed (paper cassette, MP tray, or option paper
feeder). Messages indicating the printer status (
P
QP4 P565
67 Q
) are displayed alternately.
* These messages will not appear if the number of copies is
set to 2 or more.
(
"
The waste toner bottle is not installed. Replace the old waste
toner bottle with the new one which is included in the TK-
26/29E/CTK-45 toner kit.
"
The waste toner bottle has become full. The waste toner bot-
tle should be replaced when the message display eventually
shows
.8
. See Toner container replace-
ment , page 3-4.
&
Clean the inside of the printer, according to 3.3 Cleaning
the printer , page 3-5. This message will be displayed when
replacing the toner container after the message
.8
has been displayed. After cleaning the inside
of the printer, press the GO key and the printer will be ready
for printing. If Auto Continue is set to , printing will be
automatically resumed after a preset period of time.
7R
;
Open the option duplexer rear cover, then close tightly.
5
37
The face-down output tray has become full (approximately
250 pages). Remove all printed pages from the face-down
output tray. When the printer senses that the face-down out-
put tray is empty again, it will continue printing into the
face-down output tray.
$
(paper size)/(paper type)*
*(paper size) and (paper type)
are displayed flashing alter-
nately.
Paper whose size watches the size embedded in a print job is
empty. Set paper into the paper source as displayed on the
operator panel, and press the
GO key to restart printing. The
paper source number (#) is only displayed when there is an
optional paper feeder installed. If you want to print from an
alternative paper source press the key or key to display
) ;
and you can change to another paper
source. Further, you can change the paper source by pressing
the
GO key.
After selecting a paper source and pressing the MENU key,
':
appears. By pressing the > key, the
paper type setting menu appears. After setting the correct
paper type, press the
ENTER key and printing starts.