9
Connecting the Power Cord
This section describes the procedure for connecting the power cord and various cau-
tions.
Notes on Power Supply
• Install the printer near an AC wall outlet, preferably one that can be used for
the printer alone.
• Only use this printer with the supply voltage indicated on the serial number
label attached to the printer’s rear panel.
• If an extension cord is used, the total length of the power cord plus extension
should be 5 meters (17 feet) or less.
Power Requirements
To Connect the Power Cord
• Be sure the printer’s power switch is turned off.
• Only use the power cord supplied with the printer.
1
Plug the power cord into the power cord
connector on the rear of the printer.
2
Connect the other end of the power cord
into a power outlet.
Be sure to connect to a 3-wire
grounded power strip.
Voltage
220 to 240 V ±10 %
Frequency
50/60 Hz (220 to 240 V) ±2 %
Current capacity
Max. 3.6 A at 220 to 240 V
STEP
STEP
6
Power Cord
Connector
Power Cord
IFS18+EE.book Page 9 Thursday, August 9, 2001 3:38 PM
