© 2020 Kymeta Corporation. All rights reserved.
24
10 April 2020
700-00064 revA Kymeta™ u7 terminal user manual — TRM-U7H and TRM-U7X configurations
9.7
Attach cable accessory kit
What's in the kit
The cable accessory kit consists of four 7.62 m (25 ft.) cables:
Power cable (120 VAC)
RX cable (LMR)
TX cable (LMR)
Ethernet cable (Ethernet)
The electrical tape (61 cm) is included to better protect the cable connectors.
Before you begin
Before replacing any components, familiarize yourself with
700-00065-000 Kymeta™ u7 terminal installation guide
TRM U7H U7X configurations
, section
Safety and handling instructions
.
⚠
Prior to replacing any parts, power down the u7 terminal and disconnect all power sources to avoid possible
injury from electric shock.
Avoid confusing the RX and TX cables. Before you begin to install the cables, apply colored labels to each end of the cable:
RED
is for the
TX
cable and
BLUE
is for the
RX
cable.
Cabling instructions
1.
Connect the
RX cable
(
BLUE
) to the power interface box and finger tighten.
2.
Connect the
TX cable
(
RED
) to the
BUC
. Use a torque wrench with an 8.1 in.-lb. break over.
3.
Screw an N-type to F-type adapter to the RX IN port (RX 1) connector at the back of the modem, and then
connect the
RX cable
(
BLUE
); finger tighten only.
Do not use RX 2 port.
4.
Connect the
Ethernet cable
to the
data interface box
.
5.
Screw an N-type to F-type adapter to the TX OUT port connector at the back of the modem, and then connect the
TX cable
(
RED
); finger tighten only.
6.
Connect the
Ethernet cable
from the data interface box to port 1 on the modem.
7.
(Optional)
If you want to connect your device to the Ethernet port of the modem, do the following:
If your u7 terminal configuration includes an
iDirect Evolution X7
, connect the Ethernet cable to any
modem port in the range from
2 to 8
.
If your u7 terminal configuration includes an
iDirect Velocity X7
, connect the Ethernet cable to any modem
port in the range from
5 to 8
.
8.
Connect one
power cable
to the power interface box and another one to the modem. Ensure that cable drip
loops are created to protect the power outlet from water ingress.
