SICOM3010G User’s Manual-v1.0
10
Remove SICOM3010G from DIN-Rail
The specific steps are as follows:
Step 1: Insert the screwdriver into the hole at the bottom of spring locking
plate; press the plate down to loosen the connection of DIN-Rail and switch,
as shown in arrow 1.
Step 2: Pull the SICOM3010G up in the direction of arrow 2; meanwhile
remove the switch from the DIN-Rail along the direction of arrow 3.
Figure 7 Dismounting
SICOM3010G Panel Mounting
The specific steps are as follows:
Step 1: Select the mounting position for SICOM3010G on the wall or in
cabinet; ensure that there is adequate space for the switch.
Step 2: Drill 4 holes on the selected position according to the panel
mounting dimension drawing; use a cross-screwdriver to screw 4 cross-slot
screws (M3×10) into holes. Don’t tighten the screws completely; leave
about 5mm of space between.
Step 3: Aim 4 mounting holes on SICOM3010G mounting plate at 4 fixed
screws; pass the screws through 4 holes with the diameter of 6.5mm (
Ф6.5)
;
