9
z
Remove KIEN1008G from DIN-Rail
The specific steps are as follows:
Step 1: Place the screwdriver into the hole at the bottom of spring locking
plate; press the plate down to loosen the connection of DIN-Rail and switch,
as shown in arrow 1.
Step 2: Pull the KIEN1008G up in the direction of arrow 2; meanwhile remove
the device from the DIN-Rail along the direction of arrow 3.
Figure 7 DIN-Rail Dismounting
z
KIEN1008GPanel
Mounting
The specific steps are as follows:
Step 1: Select the mounting position for KIEN1008G on the wall or in cabinet;
ensure that there is adequate space for the switch.
Step 2: Drill 4 holes on the selected position according to the panel mounting
dimension drawings; use a cross-screwdriver to screw 4 cross-slot screws
(M3×10) into holes. Don’t tighten the screws completely; leave about 5mm of
space between.
Step 3: Aim 4 mounting holes on KIEN1008G mounting plate at 4 fixed
screws; pass the screws through 4 holes with the diameter of 6.5mm (
Ф
6.5);
then slide down KIEN1008G as seen below; finally screw 4 screws tightly.
