KwiKool CeilingMaster KCA Series, Руководство по эксплуатации

Страница: 11 / 14

Page 9
VI / Installation Checklist
VII / Inspection & Maintenance
Unit Installation -
A.
Check and make sure all screws are tight and unit is secured in place.
Check and make sure inlet/outlet air exhaust are clear without blockage.
Make suer that there is adequate condenser air ventilation.
Check the condensate line and make sure that the connections are secure and that
the line is properly insulated.
1.
2.
3.
4.
Wiring -
B.
Check and make sure the unit is properly connected to the dedicated circuit breaker.
Check and make sure all wiring is properly connected and secured.
Check and make sure ground wire is tightened and secured.
1.
2.
3.
Diffuser and Filter Grill Installation
- Check and make sure that all devices for air
distribution and connected properly with no air leaks.
C.
Thermostat - Check and make sure that the 3rd party thermostat is connected
properly to unit and secured to the wall.
D.
Test Operation -
E.
Check operation with wall thermostat - Set wall thermostat to FAN ON or FAN ONLY
mode:
Fan should engage without compressor.
Set I thermostat to FAN AUTO or COOL mode operation. During cool mode
operation check and confirm that cooling is functional the 2 minute safety time
delay.
Abnormal Noise - Check and observe noise during Fan / Cooling operation
1.
2.
Drain - During cooling operation check and observe condensation drip through
normal drainage path.
3.
Air Leakage- Check for air leakage from duct and duct connection. 4.
a.
b.
Cleaning Air Filters - The air filter on the evaporator return grill should be checked at least
once a week for dust buildup. Clean the air filter or replace if needed. If the unit is used in a
abnormally dirty environment, more frequent inspection and/or cleaning may be required. A
dirty air filter will reduce the air output, resulting in a decrease of the cooling capacity of
your KCA / KCW.