3. Hardware for steps 3 through 10 is in the
Shelter Hdw
and
Bench Hdw
packs.
Attach plank hold downs to seat frame and hand tighten nut on carriage bolt at locations shown. Align plank
hold down parallel with slot in plank, insert, and turn ninety degrees (quarter turn) to attach plank to seat
frame. Center the middle seat frame on plank and tighten nuts just enough to hold the plank against seat
frames. Do not tighten at this time.
4. Attach support angles to seat frames using washer and lock nuts. Do not tighten at this time.
Plank
Plank Hold Down
Seat Frame
5/16” X 3” Carriage Bolt
5/16” Flat Washer
5/16” Lock Nut
Support
Angle
Seat Frame
5/16” Flat Washer
5/16” Lock Nut
5/16” X 2-3/4” Carriage Bolt
Support Angle
Support Angle
Seat Frame
Seat Frame
Plank
5/16” X 3”
Carriage Bolt
Seat Frame
Support Angle
Support Angle
5/16“ Flat Washer
5/16” Lock Nut
NZ448 Rev. 01/16/20
5/16" X 3" Carriage Bolt
Turn 90
°
Plank Hold Down
Plank
THIS UNIT MUST BE ANCHORED ACCORDING TO THESE INSTRUCTIONS AT ALL TIMES
THIS EQUIPMENT MUST BE STORED IN A SECURED, SHELTERED AREA WHEN NOT IN USE
OR IN THE THREAT OF HIGH WINDS. ANY WEATHER DAMAGE TO THIS EQUIPMENT WILL
NOT BE COVERED UNDER KWIK GOAL’S PRODUCT GUARANTEE. DO NOT LEAVE THIS
EQUIPMENT UNATTENDED.
WARNING
