SECTION II
Operation
P 2.2
5.
Remove the masking tape and feed the end of
the strip into the closure track until the first
closure has passed the check and is against
the stop.
6.
With the Power switch in the ”ON” position,
press the run switch to “RUN”. The closer will
cycle once and move a closure into the closing
position. The closer is now ready to close bags.
C. CLOSING BAGS:
(Figure 2.2)
1.
Grasp the bag as shown. Spin the bag to twist
the bag neck. Twisting the bag helps the
material to enter the closure smoothly.
2.
The lower hand should form a “V” to trap all of
the bag material. This helps to completely
insert the bag material into the closure opening.
3.
Do not jam the bag material straight into the
closure opening. The top hand should lead the
bottom hand. Follow up with the lower hand
until all of the bag neck is in the closure. A tight
package is accomplished by holding the
contents of the bag snugly up against the
underside of the closure track.
4.
Remove the closed bag with a horizontal
motion.
086A 08 08
Figure 2.2
Содержание 086A
