TYPE 9112-HEU
07/2014
6
Appliance hob-top panel (variants)
1)
The standards panel consists of two parts (Drawing 2):
Plate I. – a cast iron range hob with a round removable centre plate located directly under
the fire box. This plate is meant for fast cooking
Plate II. – a steel hob is located above the oven. This plate maintains a lower temperature
and thus can be used for slower cooking, simmering and keeping food warm.
2)
The single-piece ground steel finish hob-top panel.
3)
The single-piece glass and ceramic panel.
You should always use pots with flat bases.
Drawing 2
Ignition Flap (Drawing 3)
Is placed below the range and controlled by means of the lever located at the rear of the range
frame. It has the following operating modes:
Open position – Ignition and
intensive cooking
throughout the entire range area I.+II.
(Flap open)
Closed position – Baking in the oven and
Cooking on the Plate I.
(Flap closed)
Drawing 3
Following ignition, after the fire has caught, close the ignition flap and operate the appliance with
the ignition flap closed. This will influence the flow of flue-gas and increase the efficiency of the
appliance.
Содержание 9112-HEU
