4.2.5 Failed IRD Status Check
, TracVision S2 completes a detailed
startup routine whenever it is turned on. One of the first checks
is the IRD status test. As noted in the typical startup cycles, the
expectation is that the IRD and its communications link to
TracVision S2 will pass this test. There are, however, two
alternate results, each indicating a slightly different problem.
Test Result: NONE
If the system tests achieves a result of
NONE
, there is no
communication at all between the antenna unit and the IRD.
Solution
Check to be certain the IRD and TracVision S2 are connected
properly at the low-speed data port and that both are powered
on. Refer to
Section 2.3, “Connecting System Components”
correct antenna unit to IRD wiring procedures and diagrams.
After verifying the connection, cycle the power off and on and
review the startup test results.
Test Result: UNKNOWN
In the instance of a result of
UNKNOWN
, a communications link
exists, but the data received by the antenna unit is garbled and
unrecognizable.
Solution
As with a result of
NONE
, first check to be certain the IRD and
TracVision S2 are connected properly at the low-speed data port.
Refer to
Section 2.3, “Connecting System Components”
for correct
antenna unit to IRD wiring procedures and diagrams. After
verifying the connection, cycle the power off and on and review
the startup test results. If this does not initially succeed, refer to
Section 4.2.2, “AC Power Fluctuating,”
and follow the IRD reset
procedure.
4.2.6 IRD Faulty
In the case of a faulty IRD, refer to your IRD user manual for
service, replacement, and warranty information.
4-5
Troubleshooting
54-0196 Rev. A
