KVH Industries TracVision RV1, Руководство по установке

Страница: 29 / 38

28
Wire the IP AutoSwitch
The wiring of the IP AutoSwitch depends on the
specific configuration. Refer to the wiring
diagrams provided in
“DISH Network and Bell
TV Wiring” on page 15 , while following the
general wiring steps below:
a. Disconnect the RF input cable from the
receiver and connect it to the “RF In” jack on
the IP AutoSwitch. Then tighten to 15 in.-lbs
of torque.
b. Connect the supplied 2 ft (60 cm) RF cable
from the “To Receiver” port on the IP
AutoSwitch to the receiver’s satellite input
and tighten to 15 in.-lbs of torque.
c. Using the supplied Ethernet cable, connect
the “Network” port of the IP AutoSwitch to
the onboard network. If a network is not
available, install a router as shown in
Figure 47.
d. If not already connected, connect the TV-Hub
to the onboard network (see Figure 47).
e. Using the supplied Velcro strip, secure the
IP AutoSwitch to the mounting surface.
Connect up to 3 IP AutoSwitches
4 3 2 1 8 7 6 5
POE 48V
+
Switch
* Network Connections
Connect the TV-Hub and IP AutoSwitch(es) to your
onboard network. If you do not have a network, install
a router or router and switch as shown below.
Connect up to 7 IP AutoSwitches
OR
Router
12VDC
POWER
Reset Ethernet Internet 4 3 2 1
AC Power
Connect up to 2 IP AutoSwitches
Router
12VDC
POWER
Reset Ethernet Internet 4 3 2 1
To TV-Hub
AC Power
AC Power
TV-Hub
Receiver
AC Power
Satellite In
IP AutoSwitch
To Receiver
RF In
Network
** Varies depending on your system configuration
To Network*
RF Input**
Figure 47: IP AutoSwitch Connections
Continued
Installing an IP AutoSwitch
A