11
Follow the steps below to wire the receivers to the
DSWMs in the SWM expander.
a.
As shown in
, connect an RF cable
(
supplied in kit
) from the “SWM1” connector on
a DSWM to the “SWM” input on a 2-way SWM
splitter (
supplied in kit
).
b.
Connect the 2-way SWM splitter’s outputs to
the “SWM” inputs on two 8-way SWM
splitters (
supplied in kit
).
c.
Connect the 8-way SWM splitter’s outputs to
the “Satellite In” jacks on the receivers/DVRs
(or “Network” jack when connecting a Genie
client). Connect any combination of SWM
devices that add up to 13 or fewer tuners. Refer
to the table below, as necessary:
NOTE:
Genie clients reserve 0 tuners, but only
three Genie clients can be active at one time.
d.
Terminate any unused outputs on the splitters
with 75
terminators and tighten all
connections with a 7/16" torque wrench set to
20 in.-lbs.
e.
Repeat steps
a-d
to connect SWM splitters and
receivers to the DSWM’s “SWM2” connector
(see
connect any combination of SWM devices that
up to 13 tuners on “SWM2” (26 total, between
“SWM1” and “SWM2”.
f.
Repeat steps a-e to connect SWM splitters and
receivers to each DSWM seated in the SWM
expander, as needed.
SWM Device
No. Tuner(s)
SWM Receiver
1
SWM DVR
2
Genie (HR34/HR44)
5
Genie (HR54)
7
Genie Client
0
Figure 13: Wiring Up to 13 Receivers to SWM1
Deck
Polarity
Locker
AC Power
SWM Power
Inserter
SWM 2-way
Splitter
Maximum of
two splitters
per path
Terminate
unused
outputs
SWM 8-way
Splitter
SWM 8-way
Splitter
AC Power
SWM Receiver/DVR
Satellite In
Genie DVR
Genie Client
Network
R
AUDIO OUT
L
Pr
Pb
Y
VIDEO OUT
S-VIDEO OUT
DIGITAL
AUDIO OUT
ETHERNET
SATELLITE IN 1
IR RECEIVE
SATA
HDMI
PHONE JACK
POWER INPUT
USB
COMPONENT VIDEO OUT
AC Power
AC Power
Satellite In
DSWM
AC Power
SWM Power
Inserter
SWM1
SWM
Expander
When wiring the receivers, be sure to keep the
number of splits to no more than two per path.
IMPORTANT!
Wire the Receivers
8
