2-8
A Guide to TracVision SA
•
After hooking up all of the wiring and removing any
slack, slowly rotate, raise, and lower the antenna
reflector to make certain that the cables are all clear
of any moving elements.
•
Check to be certain that the elevation axis actuator
motor shaft (pictured in
) clears all cable connections.
•
Completely seal all rooftop cable access holes.
TracVision SA Cable Ports
On one side of the baseplate are four liquid-tight fittings, which
serve the dual purpose of relieving strain on the cables as well as
providing a tight seal around the cable access ports.
When wiring is done properly, the sets of cables will overlap each
other, as illustrated in Figure 2-15.
Figure 2-15
Cable Overlap within the
TracVision SA Baseplate
Figure 2-13
Moving the Antenna Reflector
Not Used
(#1)
Power
(#4)
RF
(#2)
Data
(#3)
Figure 2-14
Cable Port Assignments
(Exterior of Baseplate)
