Adjustments
33
Adjustments
I
MPORTANT
NOTE
Never turn the machine with the tool in the ground.
Working depth
The working depth of the discs is controlled by the gauge wheels.
Adjust the depth, while ensuring that the chassis remains horizontal
during operation (parallel to the ground).
Adjusting the tooth and
fertilisation depth
Lift the machine up.
Stabilise the machine.
Remove safety pin (A).
Take hold of the part to be adjusted (B for the tooth and C for fertili-
sation).
Remove the pin (D for the tooth and E for fertilisation).
Adjust the item to the desired height:
Raise the item to reduce the working depth.
Lower the item to increase the working depth.
Replace the pin (D for the tooth and E for fertilisation).
Replace safety pin (A).
Make the same adjustment on each row.
For the tine:
•
The holes are spaced 2.5 cm (
1”
) apart.
•
The high position corresponds to a depth of 10 cm (
4”
).
•
The low position corresponds to a depth of 30 cm (
12”
).
For fertilising:
•
The holes are spaced 2.5 cm (
1”
) apart.
•
The upper position corresponds to a depth of 0 cm.
•
The low position corresponds to a depth of 20 cm (
8”
).
WARNING
•
Comply fully with safety instructions.
•
Keep a safe distance during manoeuvres.
Danger of crushing and entrapment.
IMPORTANT
Do not set fertilisation lower than the tooth. This would
increase the rate of wear or break the fertilisation system.
A
B
C
D
E
