Kverneland CLC PRO, Руководство оператора

Страница: 68 / 98

Adjustments
68
Combi-disc
The combi-disc is a gang of discs used for mixing and leveling.
Adjusting the working depth of the gang of discs
•
The hydraulic jacks are used to move the roller(s). The working
depth of the gang of discs is adjusted by adding or removing the
chocks located at the jack rod. Therefore, the more chocks, the
lower the working depth of the gang of discs.
•
The roller controls the working depth of the machine; any action on
the roller/gang of discs adjustment must therefore be compensated
on the parallelogram adjustment (perforated plates) to retain the
same depth.

Raise the machine.

Stabilize the machine.

Actuate the hydraulic distributor to lower the rollers.

Add or remove bearing chocks to adjust the working depth of the
gang of discs.
•
Adding chocks reduces the working depth of the gang of discs
(less active discs).
•
Removing chocks increases the working depth of the gang of
discs (more active discs).

Apply the same setting to all roller cylinders.
Adjusting the working angle of the gang of discs
Certain positions provided on the adjustment plate may not be
accessible depending on the accessories mounted on the machine.

Check that the angle chosen is compatible with the machine’s
configuration.

Unscrew the locking bolt (A) using the 36 wrench (provided) to
release the indexing system.

Place the 36 wrench on the handling assistance nut (B).

Rotate the gang of discs to the suitable angle using the wrench.

Make sure that the indexing system is located at a predefined
position.

Re-tighten the locknut.
A
B