Preparing for operation
19
Remove paint
Remove paint from all surfaces in contact with the ground. Use a
scraper and paint remover.
Control system
The control system consists of a front control cylinder and a rear con-
trol cylinder coupled in series. As a safety measure, there are 2 accu-
mulators fitted between both cylinders to ensure steady movement
during transport and when driving around tight bends at headlands.
When turning with the tractor, the front cylinder which is coupled in to
the drag axle will activate the rear cylinder so that the plough follows
the rear of the tractor.
If the tractor, plough and wheel are parallel, the arrow on the depth
wheel must be set so that the arrow and the sticker are aligned. You
can close the taps during road transport and ploughing.
T
IP
! By opening the taps and using the hydraulic function with the control
active, the wheel can be controlled independently when parking and
on tight bends. NB This must only be used at low speeds.
NB! You must ensure that the wheel is returned to the parallel po-
sition when restarting ploughing.
During road transport, the tap must be closed to prevent accidental
movement of the wheel.
