Kvaser Hybrid Pro 2xCAN/LIN User’s Guide
11 (23)
4
Appendices
In this section you will find technical information about the Kvaser Hybrid Pro
2xCAN/LIN and its connectors.
4.1
Definitions of LED states and colors
The Kvaser Hybrid Pro 2xCAN/LIN has three types of LEDs; Power, Traffic and
Info. These are dual colored as shown in Table 3. A device with multiple channels
has one Traffic LED for each channel. When the device has more than one
channel a space and digit is added on the label, CH 1, CH 2 etc. The red Traffic
LEDs are also used to indicate errors by using all red Traffic LEDs simultaneously.
LED
Label
Color
Power
PWR
Green/Yellow
Traffic
CH
Yellow/Red
Info
INFO
Green/Yellow
Table 3: The different type of LEDs.
The following definitions is used to describe the state of an LED:
Off
The LED is off and no light is emitted.
Flash
The LED is lit up for a very short time. A single flash may be hard to see
and a continuous set of flashes will look the same as On.
Slow Blink
The LED is repeatedly turned On and Off. The On and Off phase is
equal in time.
Fast Blink
The LED is repeatedly turned On and Off but with a higher frequency
than Slow Blink. The On and Off time is still equal.
On
The LED is constantly emitting light.
Slow Waver
This is a variant of Slow Blink but instead of being Off, a second color
is On. This is only possible with a dual colored LED.
Fast Waver
The LED is alternating between two colors as in Slow Waver but
using a higher frequency.
Running
This means that all LEDs are lit, one at the time, in sequence with every
color available i.e. “Power green->Power yellow->Traffic 1 yellow->Traffic 1
red->Traffic 2 yellow->Traffic 2 red->. . . ”
Kvaser AB, Mölndal, Sweden — www.kvaser.com
