After a power failure or interlock failure (open circuit) has occurred and been corrected you need
to manually reset laser emission by pressing the START button on the E-STOP Remote. Laser
emission will then be available after a 60 second emission delay.
5.
DMX INPUT/THROUGH.
Once set up and switched to DMX control mode, this laser display
system can be controlled via DMX from any standard DMX control device.
6.
Control signal INPUT/OUTPUT.
Use one of these ethernet sockets to control the laser over CAT5
cable (using inbuilt FB4-MAX control interface). The other ethernet socket is used for plugging
additional lasers into the network (network daisy chain).
7.
Pangolin FB4-MAX interface
. All the basic laser system settings, network settings and control
options are set in here. Please refer to Pangolin’s FB4-MAX user manual for more information.
8.
ILDA INPUT/OUTPUT.
ILDA INPUT connector is used for the control signal input from an external
control interface. ILDA OUTPUT connector is used to daisy chain the control signal between
multiple laser systems.
9.
Safety eyelet.
Use this together with appropriate safety wire to secure the system against
unexpected fall.
Please note that in most countries it is required by law to have a fully working
Emergency STOP in place for every laser system used. If you use supplied interlock
connector to defeat the safety interlock you must have another method in place to be
able to kill laser output instantly in case of emergency.
!
Kvant spol. s.r.o.
Spectrum series - v16816
Page 23 of 38
Содержание Spectrum 20
Страница 1: ......
Страница 16: ...Interlock Connection Diagram Kvant spol s r o Spectrum series v16816 Page 14 of 38 ...
