Kval 979-2, Руководство по эксплуатации и обслуживанию

Страница: 44 / 112

3.
Adjust the end stop for the cut angle. The end stop
distance is determined by the fixed head cutting
angle:
• For 45 degrees, set the end stop for the same distance
as the stock width.
• For 0 degrees, set the end stop distance for 0 inches.
Set to Stock
Width
‘0’
inches
4.
Set the front edge clamp distance on each head
to the same as the stock width.
5.
Set the jamb clamp width air valves. For stock less than
3 ½ inches, the valve must be slid toward the input side
of the machine. For stock greater than 3 ½ inches, the
valve must be slid toward the out-feed side of the
machine.
Mechanical Set Up
2-19
KVAL 979-2 Operation/Service Manual
6.
Load the Hopper.
7.
On the Touch Screen press and hold the Start Saw button to start the saws.
8.
Press the feed in foot pedal to start the machining of the product.
NOTE: Wide jamb mode has better clamping ability than narrow jamb mode; tighter
clamping produces cleaner saw cuts. Wide jamb mode can be used on narrow stock.
The disadvantage is that wide jamb mode is slower by about 3 boards per minute.