Conversion to different gas types
If the device will be operated with a gas other than specified on its label, perform following procedures. Required
nozzles and adhesive labels are provided in a bag with the device.
Replacement of burner nozzle (figure B)
Remove the device control panel.(4)
Disassemble nozzle “1” from nozzle connector , and replace it with new one according to gas type
Adjust the burner air
Replacement of pilot burner nozzle (figure-B)
Remove the device control panel.
Remove screw “2” and replace nozzle “3”with new one according to gas type
WARNING:
If any conversion to another gas is performed for the device, you
must place the adhesive label corresponding to the utilized gas on a visible
part of the device.
OPERATION
Pan control
Positions of the thermostat control button (B) are as follows:
0 Off
50
0
C Minimum temperature
100÷250
0
C Medium temperatures
300
0
C Maximum temperature
Positions of the gas control button are as follows:
● Off
¥ Pilot burner ignition
SS
Maximum flame
Ignition of Burners (fig C)
Open the feeding valve on the gas network.
Turn the gas control button “5” to position “Pilot burner ignition”(7) and push down. At the same time, press down the
piezoelectric ignition button, as well. So, the spark needed for pilot burner flame is produced. Release gas control button
approximately after 20 seconds. Pilot burner flame will continue to burn. If does not burn, repeat ignition process again.
Ignition may be checked through “flame observation port” (10).
In order to ignite burners, turn the gas control button to position “maximum flame” (6).
Adjust thermostat control button (9) to desired cooking temperature.
It is enough to turn the valve (11) left to take water in the chamber.
ATTENTION:
Pay attention to have the pan on full lateral position while using the device. Otherwise, microswitch
will cut off the gas to the main burner.
Turning off Burners
Turn thermostat control button (9) to position ''0''.
Turn gas control button(5) to position “off”.(6)
Close the valve on the gas network.
Pan lifting
Pan can be pulled up and down through its special mechanism “12”. In order to pull up the pan, lock the rotation
mechanism with its pin and turn it clockwise. In order to pull down the pan (to cooking position), turn the mechanism
anti-clockwise.
ATTENTION:
Do not try to pull up the pan without removing its upper cover.
