Kurzweil CUP2A, Руководство пользователя

Страница: 8 / 26

page 2
Introduction
Power Connection
Standard AC current supplies the Andante CUP2A’s power. Before connecting the AC power cord, make sure that the
power on/off switch (located on the right end of the keyboard) is in the
OFF position.
Connect the AC power cord to the AC receptacle on the rear panel of the Andante CUP2A. Then connect the power
cord to an AC outlet.
CAUTION :
The Andante CUP2A runs on AC power and works with voltages from 100 - 240 volts at
50–60 Hz. The voltage level is detected and set automatically by the CUP2A.
Do not attempt to connect the power cord to a non-standard AC power source.
The AC plug shape will vary
depending on location of use
After the CUP2A is set up, turn the power on. While the unit is performing its power-up routine some of the front panel
buttons will lash. After a couple of seconds, the display will read
1 Grand Piano . The CUP2A is now ready to play.
Use the Quick Start instructions on the following pages for the basic steps to change Voices or play one of the Demo
Songs.
Volume
Before turning on the Andante CUP2A, it’s always a good idea to set the volume at its minimum setting (all the way to
the left). For a generally comfortable level of volume while playing, set the knob at its middle position.
The Volume Control is located on the front of the control panel
. Turn this knob from left to right (clockwise) to increase
the volume. This adjusts the Andante CUP
2A speaker and headphone audio volume. The Volume control does not
affect the volume of the sound coming from external sources through the Audio In jacks.
See Settings Mode
to adjust tone controls for this instrument.
Headphone Jacks
The CUP2A
has two stereo 1/4” headphone jacks located
on the front face of the slide-out control panel.control panel.
Plugging in headphones provides privacy during practice. Both jacks operate the same so two people can play and
hear the music together. When headphones are connected the CUP2A’s speakers are silent.