Kurzweil CUP2A, Руководство пользователя

Страница: 17 / 26

page 11
Settings, con’t
Touch
Use this parameter to adjust the keyboard touch sensitivity to your
playing technique.
Press the Settings
button until the screen displays
Touch:Linear (factory default). To change the setting, press the
Next+
button to advance to the next desired Touch. Press the
Prev-
button down to reverse the steps. The following
are the available settings:
Linear Best Dynamic Range for all sounds (Factory Default Setting).
Light (1-3) For
players with a light touch. Adjust this parameter to achieve a good dynamic range. These settings
are from Light 1, a slightly light touch, to Light 3, a very light touch.
Hard (1-3)
For players with a heavier touch. Adjust this parameter to achieve a good dynamic range. These set
-
tings range from Hard 1, a slightly harder touch, to Hard 3, a very hard touch.
Piano Touch Best for piano dynamics.
Easy Touch Light touch, especially for younger players.
GM Receive
Select this when playing General MIDI songs.
The Touch setting is remembered across power cycles. Pressing the
Prev- / Next+
button pair will reset the Touch
level back to
factory default of Linear .
Tune
This parameter allows you to adjust the Andante CUP
2A tuning to match other instruments or recordings.
Press the Settings
button until the display reads
TUNE:0 (factory default is A - 440). To increase the tuning, press
the Next+
button from 0 to 100 cents. To lower or reduce the tuning, press the
Prev-
button from 0 to -100 cents.
Pressing Prev- / Next+
button pair will reset the tuning back to factory default of 0 or A-440.
Treble
Press the Settings
button until the display reads
Treble:0 . Press the +Next
button to increase treble; press the
Prev-
button lower it.
Pressing the Prev- / +Next
button pair will reset the treble EQ back to factory default of 0.
Bass
Press the Settings
button until the display reads
Bass:0 . Press the +Next
button to increase bass; press the
Prev-
button lower it.
Pressing the Prev- / +Next
button pair will reset the bass EQ back to factory default of 0.
Top Speaker Level
This setting controls the level of the speakers under the top lid of the CUP2A. The volume ranges between 9 (maxi
-
mum) and 1 (minimum). Pressing Prev- / +Next
button pair
will reset the Top Speaker Level to factory default level.
MIDI Channel
This parameter controls the MIDI transmit channel used for
Voice Mode . Press the Settings
button until the display
reads CHANNEL: 1 (Factory Default). You can select Channels 1 through 9, or Channels 11 through 15. Channel 16
is reserved for the metronome. Pressing the Prev- / Next+
button pair will reset the MIDI Channel back to the factory
default of 1.
For more information on MIDI, see the following section of this manual.