page 16
Song Mode
Tempo, Rec.Rthm, and Rhythm Vol
The Tempo, Rec.Rthm, and Rhythm Vol parameters can be adjusted for each song. After selecting a song,
use the UP and DOWN navigation buttons to select the desired Tempo, Rec.Rthm, or Rhythm Vol parameter,
then use the LEFT and RIGHT navigation buttons to change the settings of the selected parameter.
● The Tempo parameter adjusts the tempo of the current song in beats per minute (BPM).
● The Rec.Rthm parameter controls whether a Rhythm Pattern plays during recording.
If you record a song and want the Rhythm Pattern recorded as well, be sure to change this parameter to On.
● The “Rhythm Vol” parameter controls the volume of the Rhythm Pattern.
The volume range is from 0 (minimum) to 10 (maximum). The default volume setting is 5.
This setting is not saved per song, but instead applies to all songs.
Correcting Mistakes (Punch-in Recording)
You can fix mistakes in your performance by doing “punch-in” recording. Punch-in recording allows you to re-record
a section in the middle of a song. This is useful for correcting mistakes without recording the whole song again.
Follow these steps to perform a “punch-in”:
1. Select a previously recorded song and press the PLAY/PAUSE button to begin playing.
2. When the song reaches the part you need to correct, press the RECORD button and play the corrected notes.
3. After playing the corrected notes, press the STOP button to stop recording. The start and end sections of the
song will remain unchanged. If you don’t press the STOP button after you punch-In, you will erase the remaining
portion of the song. Changes to the song are saved automatically.
Selecting Metronome and Rhythm Settings
Press the MET/RHY/TAP button to enter Metronome/Rhythm Mode, where you can select a Rhythm Pattern and
Metronome settings. See the Metronome/Rhythm Mode chapter for more details on these parameters.
Press the EXIT button to return to Song Mode.
Erasing a Song
You can erase a song by recording “nothing:”
1. Press the RECORD button.
2. Press the PLAY/PAUSE button to begin.
3. Press the STOP button again.