Kurz
Instruments, Inc.
831-646-5911
2411 Garden Road
www.kurzinstruments.com
Monterey, CA 93940
360208-F 454FTB, 504FTB, 534FTB
2
The following information is an abbreviated list of what you need to do for your flow
meter to achieve maximum possible repeatability and accuracy. Most of the steps will be
required for all products. Please read this before you start.
You will ultimately need to refer to the product manual, which is found on the attached
CD. Given the Model number of your product, you can find the manual you require.
Unpacking/Expected Content
Your flow meter has been shipped to you with the following items. Please make sure you
have them and contact us if this is incomplete.
1.
Flow meter, compare the packing list against your order.
2.
Calibration certificate
3.
Manual on CD
4.
Menu Quick Lookup Card
Mounting of the equipment (see guidelines sheet)
You will need to remove the protective shipping covers from the sensor or flow body
before installing the unit. A thermal meter must have direct contact with the process fluid
to work. The meter will need to be mounted in accordance to safe design practice
accounting for the process pressures, corrosion, temperature and any potentially
hazardous area requirements. The electronics head needs to be in an accessible area so
you can do the wiring and access the local keypad/LCD if applicable. Some models have
remote electronics heads, which must be mounted/wired too. Most units can be
programmed with a Laptop portable
computer using the USB interface and PC
driver.
Each meter has a flow arrow mounted on
the outside of the enclosure that provides
a convenient mounting reference. The
flow arrow direction points in the
direction of the flow. For best results,
please carefully look over the installation
guidelines sheet for more on the sensor
placement criteria.
Insertion Meters
must be mounted with a
compression fitting to the duct/pipe or
+ Kurz Model # =
