25
3BA00215 • 2016-07-11 • Rev. 3
ersa X-TOOL VARIO
8.3.3
Cleaning respectively replacing sintered filter discs
■
Remove the heating head, as described in Chapter 8.4.
■
With tweezers, carefully remove the sintered filter
disc from the silicone holder.
■
Clean the sintered filter disc in an alcohol bath. Con
-
sider using an ultrasonic bath to remove stubborn dirt.
■
Insert a new sintered filter disc into the silicone
holder.
■
Re-assemble the heating head, as described in Chapter
8.4.
■
Re-install the residual solder pot.
Caution! Material damage is possible!
Always make sure that the pre-filter, filter plug and sintered filter disc are
properly installed before using the tool.
8.4
Replacing the heating head
■
Disconnect the tool from the control station and let it
cool to room temperature.
■
Remove the tip and the residual solder pot.
■
Press the two latches
①
on both sides of the heating
head cover and pull this off.
■
Carefully pull out the heating head with the silicone
holder.
■
Remove the silicone holder.
■
Place the silicone holder on the new heating head.
■
Install the new heating head and close the heating
head cover again.
■
Re-insert the tip and the residual solder pot.
■
Re-connect the tool to the control station.
Maintenance and servicing
