Kurt 360PWS, Руководство по эксплуатации

Страница: 4 / 20

4 ENGLISH | Installation & Assebly Guide
Installation & Assembly Guide
This workstop is a precision tool and must be handled carefully. You
will need a set of Hex wrenches to install it properly.
Begin by following the steps listed.
1. Using one of the ½ -13 SHCS, attach item 3 (Body Clamp) to the
vise with the 45-degree angle down and in towards the body of
the vise. Do not tighten the SHCS at this time.
2. Using the other ½-13 SHCS, attach item 5 (Pivot Body Clamp) to
the vise with the 45-degree angle down and in towards the body
of the vise as shown in fig. 3. Then insert item 6 (Pivot Stop Collar)
into item 5 as shown in fig. 1. Do not tighten the SHCS at this time.
3. With both the Body Clamps in place, you can slide item 1
(Mounting Rod) though the clamps. Tighten the SHCS finger tight
at this time.
4. With item 4 (Rod Clamp) in hand, you can install the two 10-24
x7/8 SHCS. Take note of the threads in the rod clamp so you are
sure that the screw is installed from the correct end. Finger tight
only.
5. Slide the Rod Clamp on to the mounting rod on the side you wish
to use the stop.
6. With the Rod Clamp in place, tighten slightly so it does not rotate
on the mounting rod. Slide the Stop Rod into the Rod Clamp and
slightly tighten the SHCS.
7. With the Stop Rod in place you can install the last two SCH screws
(item 9: 10-24 x 5/8) into the end of the Stop Rod. (It enters from
the side with the flat on it.) Then install item 11 (5/16-18 x 1.00), the
SHSS into the other hole perpendicular to item 9. This acts as the
stop point for the workstop.
NOTE: The installation is done by assembly the unit on the backside of
the vise (the end opposite the handle).