–
If you press the clock button twice, you prolong the delayed stop time to
30 minutes; pressing it three times gives you a delayed stop time of one
hour.
–
In order to change the preset delayed stop time, press the clock button
repeatedly until the control lamp for the desired delayed stop flashes. The
delayed stop time now starts again at zero.
–
During the delayed stop time you
can naturally also switch off the
hood when you want.
The cleaning interval for the fat filters
After about 100 hours of operation
the right-hand control lamp on the
control panel flashes to remind you
that the fat filters have to be cleaned.
–
Press the right-hand button on the control panel to switch off the control
lamp. This resets the working hour counter to 0.
–
Then switch off the power circuit for the hood (de-activate fuse) and
clean the fat filters (see Section “Cleaning the metal fat filters”).
General instructions on use
in extraction mode
in recirculation
mode
Appliance
Switch on
appliance
on starting cooking
on starting cooking
Switch off
appliance
ca. 5 min. after
finishing cooking
ca. 15 min. after
finishing cooking
Position of
Door
open
closed
Window
closed
open
The room
air is cle-
aned of
Moisture
X
—
Heat
X
—
Fat
X
X
Odours
X
X
Cleaning and maintenance
Danger! Before all cleaning and maintenance work disconnect the
appliance from the power supply by pulling out the mains plug or
by switching off the household fuse!
Caution! Do not use any abrasive or sharp cleaning agents!
–
Clean the hood on the inside and outside with a damp cloth and a mild
liquid detergent.
Control panel
–
Carefully wipe the control panel now and again with a soft cloth which is
free of fluff.
Glass surfaces
–
Clean the fume trap and the glass shelf with a damp cloth and a little
hand detergent or one of the usual glass cleaning agents.
Stainless steel parts
–
Clean stainless steel parts with a damp cloth and a little washing-up
liquid. Then wipe dry. Use one of the usual stainless steel cleaning
agents from time to time.
Cleaning the metal fat filter
The metal fat filter must be cleaned when the right-hand control lamp on
the control panel flashes.
–
Undo the screws holding the metal
mesh under the hood.
–
Remove the mesh and the fat
filter.
–
Clean both of them in a dish-
washer or by hand with a mild
liquid detergent. Rinse and dry
well before installation.
–
Insert the filter and the mesh
again and screw tight.
–
If, after the filter has been cleaned, the right-hand control lamp on the
control panel still flashes when the hood is switched on, press the right-
hand button to reset the hour counter to zero and switch off the lamp.
Changing the battery of the remote control
When the hood no longer reacts to the buttons on the remote control, you
probably have to change the battery in the remote control.
–
Remove the cover of the remote control.
–
Undo the battery connections.
–
Remove the battery, insert a new one (9V E-block) and connect it.
–
Close the cover again.
IKD 908.1
17
