18
EMG 457.0 / EMGF 457.0
What to do if trouble occurs
Unplug the appliance before repair!
First check whether there has been any operating error. You can deal with
some problems that occur yourself.
Important note:
Repairs should only be carried out by a qualified and authorised trained
installer!
Even during the guarantee period repairs will not be free of charge if due to
incorrect operation or to non-adherence to our instructions given under “What
to do if trouble occurs”.
Should you need to contact Customer service or order spare parts, always
quote the information printed on the model identification plate. The rating label
is located at the bottom side of the hob. You will also find it stuck onto the
front page of the operating instructions enclosed.
Cleaning and Care
=
Never clean the glass ceramic hob with a steam cleaner or similar
appliance!
=
Never use cleansers which contain silicon, since these leave behind a
protective film, i.e. residues, which could get into the food that is cooked
next. Therefore, follow the instructions of the manufacturer in this regard.
■
Clean the hob every time after use.
■
Only use the supplied cleaning scraper to
remove food residues.
■
Never use abrasive materials such as steel
wool or abrasive cleansers!
■
Be especially caref ul to keep the sensors
clean since soiling could be mistaken for
finger contact by the appliance.
Never put anything (pans, tea towels etc.) onto the sensors! If food boils
over onto the sensors, we advise you to activate the emergency switch.
■
Make sure that no cleaning residuals remain on the cooking zone.
F
Residues of cleaning agents can cause discolouring the next time you
switch it on. Cloths and sponges which are used for the cleaning of other
surfaces can cause discolouring.
■
We recommend cleaning the hob with half a lemon or lemon juice. This
enables slight protein residues, e.g. from meat, to be removed easily and
makes the hob gleam again.
Using a cleaning scraper
=
Caution! Risk of cutting! The blade of the
cleaning scraper is very sharp!
Always hold the cleaning scraper flat to the surface
and push the grease away from you.
=
Do not scratch the surface with the edge of
the scraper.
Cleaning the cooking zone
=
Make sure that no cleaning residuals remain on the cooking zone.
– First of all remove all food residuals and fat splashes from the hot cooking
zone by means of the cleaning scraper.
– Clean the cooking zone with water and some detergent.
– Rewipe it with clear water and finally dry it.
F
In case there are still some soil particles left on the cooking zone after
cleaning, they can easily be removed by means of a special cleansing
agent, e.g. VSR O-FIX-C (available from the Küppersbusch Customer
service). Then wipe off the entire cooking zone with a wet and afterwards
with a dry cloth.
Fault
Cause
Remedy
Not possible to
switch off the hob.
Faulty electronic
component.
Disconnect the fuse,
call Customer service.
LED display for
cooking settings and
heat display does
not come on or only
partially.
LED display
defective.
Call Customer service.
Risk of burning, as the
temperature warning is not
guaranteed.
Cooking zone does
not heat up.
Household fuse
defective.
Check and replace fuse, if
necessary.
Cooking zone
defective.
Call Customer service.
Inner circuit of the
cooking zone
defective.
Under no circumstances
continue to use the outer circuit
which is still working!
Immediately call Customer
service.