33
EN
Basic settings
Water Hardness setting
The
appliance
features
a
system
that
automatically indicates when it is time to descale.
The system can be optimised for households with
very soft water (also through using a water
softening appliance) and very hard water, by
changing the user settings to the relevant range of
water hardness (see table below).
To set the water hardness parameter, proceed as
follows:
1. Press the
Start/Stop
key and the
Function
selection
key simultaneously. The hardness
number will start to flash on the display (not
necessary if your oven is first plugged in or
after a power failure).
2. Turn the rotating knob to set the correct water
hardness parameter value, according to the
below table.
3. Press the
Clock
key to set the parameter. The
display shows the clock.
Water hardness
Type
Ca + Mg
(ppm)
English deg.
[°eH]
French deg.
[°dF]
German deg.
[°dH]
Display
Soft water
0 to 150
0 to 11
0 to 15
0 to 8
1
Medium water
151 to 350
12 to 25
16 to 35
9 to 20
2
Hard water
501 to 500
26 to 35
36 to 50
21 to 28
3
Safety blocking
The oven functioning can be blocked (for example, to stop it being used by children).
1, 2
1. To block the oven, press the
Start/Stop
key for
3 seconds. You will hear a sound signal and
the
display
will show the word “SAFE”. The
oven is blocked in this state and cannot be
used.
2. To unblock the oven, press the
Start/Stop
key
again for 3 seconds. You will hear a sound
signal and the
display
will show the clock
again.
The clock can be seen by pressing briefly the
Start/Stop
key.