Electric connection
The hood is fitted with a normal mains plug and there should therefore be a
socket outlet (230 V AC) near the point of installation.
Recirculation mode
There are no other preconditions for the customer.
Extraction path to the rear
There must be an exhaust channel
150 mm in diameter through the
wall inside the chimney surface.
Extraction path upwards
There must be an exhaust channel
150 mm in diameter inside the chim-
ney surface in the room ceiling abo-
ve
the installation point of the hood.
Mounting a steel rear panel (optional)
With a telescopic rear panel set the length you want.
–
Mark the drill holes.
–
Drill the holes and insert dowels.
–
Insert the bottom edge of the rear panel behind the worktop or the built-
in hob. The rear panel must rest on the worktop.
–
Guide the power cable through the opening in the rear panel and screw
on the panel.
Attaching wall hooks and chimney support
Caution!
When the hood is installed, the distance between the
hood and the cooker must be at least 650 mm.
Establish the chimney length accordingly.
The wall mounting must be aligned with a spirit level.
Correct alignment of the hood is only possible if you perform this work
accurately.
If the hood is connected to an exhaust channel, make sure that the ex-
haust opening is inside the chimney surface and the hood is located cen-
trally above the hob.
The chimney support can be attached to the wall or to the ceiling. The
upper edge of the chimney support corresponds with the upper edge of
the chimney.
–
Place the drill hole template centrally above the hob. The lower edge of
the template corresponds with the lower edge of the hood.
–
Mark the holes for the wall hooks and locking screws.
–
Mark the holes for chimney support centrally above the above the holes
for the wall hooks. For this, the chimney support must held up in the in-
tended position.
–
Drill holes with a
∅
8 bit and insert wall plugs.
–
Attach the brackets with the wall
screws (B).
–
Release the clamping screws (A).
–
Screw in the chimney support tightly.
–
Remove the metal-mesh grease filter from the hood.
or
16
KD 934.1 / KD 634.1
