H1-01-08
5
For internal use only
2.
Description of the functioning of the touch control for
5 zones (EKE 854.1) and pan sensor (EKE905.2F)
Please note the safety instructions!
Subsequent to initial connection and after a power failure
CAL
will appear briefly in the LED displays.
Rotating, circling symbols will then be indicated. This means that the sensors have been checked
automatically and that the touch sensitivity has also been newly set.
Confirm this indication by touching the OFF sensor. These symbols will be switched off immediately if
there are no objects on the sensors. Otherwise remove any objects and disconnect the cooking zone
briefly from the mains (fuse) once again.
Important: No objects must be lying on top of the sensors when adjusting the sensor’s
sensitivity.
2.1
General adjustments to the software / hardware of the touch
control for 5 zones without a pan sensor used until now
1.
An additional LED has been installed below the dual-circuit key. It signals that the second circuit
has also been activated for cooking zone 5.
2.
The decimal points in the display indicate the pan sensor situation should the touch control have
been configured for the pan sensor.
•
Decimal point does not light up: pan sensor active
•
Decimal point lights up: pan sensor for the respective zone deactivated
•
Decimal point blinks: pan sensor fault recognised
3.
Certain functions can now be activated or deactivated by entering a code.
A code entered is activated when the hob is switched off by pressing both the plus sensor and the
dual-zone sensor of zone 5 simultaneously (for approx. 5 sec.).
An alarm buzzer will sound briefly and the display will show
C.00.0
. In this case “C” stands for
Code and the next two zeros stand for the code number of the respective function. The last zero is
the point at which the function is activated or deactivated. The code numbers are set with the plus
key of the respective zone. In the display for zones 3 and 4 numbers between 0 and 9 can be set
and in the display for zone 2 a setting between 0 and 1 can be made.
Once the required code number has been set, it is confirmed and the respective action is carried
out by pressing the two minus keys for zones 2 and 3 simultaneously. A short acoustic signal will
also sound.
Codes:
Activate pan sensor calibration
C.63.1
Switch off the pan sensor mode
C.72.0
Switch on the pan sensor mode
C.72.1
Switch off the demonstration mode
C.81.0
Switch on the demonstration mode
C.81.1
Switch on the operation mode for Europe
C.10.0
Switch on the operation mode for the USA
C.10.1
If an incorrect code number is set, the code setting will be deactivated again and the display will go off.
If the code setting has been activated and no corresponding key is pressed for approx. 10 seconds, the
code setting will also be deactivated.
