Kuppersbusch CSV6800.0, Инструкция по использованию и установке

Страница: 13 / 56

english
Problem Cause Solution

The blade placed under the Teflon
of the sealing bar is broken.

Replace the blade (contact the Technical
Assistance Service for a replacement).
Final vacuum is
poor

The set vacuum percentage is
incorrect.

Change the vacuum percentage.

The cover gasket is dirty or worn.

Clean or replace the cover gasket (contact the
Technical Assistance Service for a
replacement).

The cover is not closed correctly.

Close the cover correctly.

Make sure that objects or dirt are not found
between the cover and tank.
The cover does not
open

No power supply.

Wait until the power supply is restored.
If the machine does not work properly after
the above-mentioned checks, contact the
assistance service describing the detected
defect.
ALARM MESSAGES
The circuit board detects some alarms,
which are displayed with the following
messages:
Error Solution
E0
Eprom Error.
The main board is faulty.
Contact the technical assistance service.
ER1
Data configuration error.
Contact the technical assistance service.
ER2
Calibration error.
Re-adjust the control board through a suitable vacuum gauge.
Contact the technical assistance service.
ER3
Cycle counter error.
Contact the technical assistance service.
ER4
Faulty sealing relay.
Contact the technical assistance service.
ER5
Vacuum Timeout: overtime.
Ensure the set vacuum percentage is correct.
Ensure the cover gasket is not dirty or worn.
Make sure the cover closes correctly.
ER7
Oil maintenance.
The machine has exceeded the number of cycles beyond which oil replacement is
required.
Contact the technical assistance service.
Disposal of the packaging
The packaging bears the Green Point mark.
Dispose of all the packaging materials such
as cardboard, expanded polystyrene and
plastic wrapping in the appropriate bins. In
this way you can be sure that the packaging
materials will be re-used.
Disposal of equipment no longer used
According to European Directive 2012/19/EU
on the management of waste electrical and
electronic
equipment (WEEE), home
electrical appliances should not be put into
the normal systems for disposal of solid
urban waste.