Kunzle & Tasin Bona Edge UX, Руководство по эксплуатации и техническому обслуживанию, Страница: 10 / 145

EN
Bona Edge UX Bona Edge UX
18 19
Routine Maintenance (Cont.) Routine Maintenance (Cont.)
Graphite brushes Replacing led strip
Unplug the machine from power supply, before remove 3
screws on the upper black shell.
Follow the 'Graphite brushes'
(pag.17) up to point 3.
Remove the end fixing screws
on the wire for each brush,
then pull the brush spring
backwards and remove the
brush.
1.
1.
3.
2.
2.
4.
Remove the burnished screws from rear shell.
Remove 2 screws on the led guard and replace led strip.
3.
Reassemble all parts.
The motor has two graphite brushes that must be checked every six months or after 500 hours of operation.
The check the brushes carry out the following procedure:
Check the brushes. If one of
the brushes is shorter than
12 mm replace both brushes.
When fitting new brushes, ensure the cables are away from the motor, before remounting
the cover.
Replacing dust capture strip
Follow the 'Replacing the
cogged belt' (pag.16) up to
point 3.
1. 2.
Remove 2 screws on the side arm and internal plate.
Sawdust chamber
Disc
Hoover the sawdust from the chamber regularly to prevent the hazardous accumulation of dust.
Check the disc surface regularly. Remove any dirt.