Kunzle & Tasin Bona Belt UX, Руководство по эксплуатации и техническому обслуживанию

Страница: 27 / 340

Bona Belt UX Manual
27
EN
Troubleshooting (Cont.)
PROBLEM CAUSES SOLUTIONS
The thermal protection inter-
venes too much frequently
Wrong or unstable power supply Try the machine on a different job-site
Excessive cable length or unsuitable
cross section
Use cables of suitable length and cross section
Too much weight on the machine Remove any possible additional weight on the machine
Dirty motor
Check if the motor is well clean and remove all
the possible dirt
The fan is not turning properly
Check if the fan is well screwed or contact an authorized
Bona dealer for fan bearings replacement
Faulty thermal switch Contact an authorized Bona dealer
Faulty motor Contact an authorized Bona dealer
The drum release lever is too
hard or doesn’t stop at the high
position
Release pin and spring not enough lubricated or
damaged Lubricate them or contact an authorized Bona dealer for
replacement
Lever sector plate or lever stop pin dirty, not
enough lubricated, damaged, worn-out or
broken
Clean or lubricate them, or contact an authorized Bona
dealer for replacement
The drum doesn’t come off
enough from the floor
Wheels joint, between the two parts of
the drum lifting rod, not properly adjusted
Adjust it at the right position
Dust is locking the wheels support Clean it
The abrasive belt
doesn’t stay in its
position
Tensioner not properly adjusted Adjust it (check the alignment with the rubber drum)
Spring of the tensioner not working properly Contact an authorized Bona dealer
Excessively or irregularly worn tensioner Contact an authorized Bona dealer for replacement
The abrasive doesn’t
sand enough or its
speed is not enough
Worn-out or unsuitable abrasive Replace it
Drum pressure is not enough Increase the drum pressure
Dust prevents adjusting the drum pressure Remove the dust
Driving belts at a wrong tension Set them at a right one
Tensioner dirty or too worn-out Clean it or contact an authorized Bona dealer for
replacement
Worn-out driving belts or pulleys or bearings Replace the driving belts or contact an authorized Bona
dealer for replacement of pulleys and bearings
The floor surface is not
regularly sanded
Faulty abrasive belt Change it
Not correct wheels position Adjust the wheels at a right position
Bearings, pulleys or shafts dirty or faulty Clean or contact an authorized Bona dealer for
replacement
Driving belts and wheels dirty, badly adjusted or
faulty Clean, adjust or replace them
Drum surface dirty or faulty Clean, correct or replace the rubber-coated drum
The floor surface turns
scorching
Worn-out or unsuitable abrasive Replace the abrasive
Excessive pressure on drum Decrease sanding pressure
Insufficient dust collection
Dust bag more than 1/3 full Empty the bag
Dust bag dirty or with blocked pores Shake out the dirt and wash the bag
Vacuum ducts and/or obstructed pipes Clean air ducts
Suction bearings and shaft in bad conditions Contact an authorized Bona dealer