14
15
KWM5315
EN
washing machine
1.
Rigid, dry, and levelled surface
2.
Avoid direct sunlight
3.
Sufficient ventilation
4.
Room temperature above 0° C
5.
Keep far away from heat resources such as coal
or gas.
Unpacking the washing machine
Warning!
• Packaging material (e.g. films, Styrofoam) can be
dangerous for children.
• There is a risk of suffocation! Keep all packaging
far away from children.
1.
Remove the cardboard box and Styrofoam
packing.
2.
Lift the washing machine and remove the base packing. Make
sure the small triangle foam is removed with the bottom one
together. If not, lay the washing machine down on its side, then
remove the small foam from the unit bottom manually.
3.
Remove the tape securing the power supply cord and drain hose.
4.
Remove the inlet hose from the drum.
Removing the transport bolts
Warning!
• You must remove the transport bolts from the back of the washing
machine before using it.
• You will need the transport bolts again if you move the product, so
make sure you keep them in a safe place.
Please take the following steps to remove the
bolts:
1.
Loosen the 4 bolts with a spanner and then
remove them.
2.
Plug the holes with transport hole plugs.
3.
Keep the transport bolts for future use.
Levelling the washing machine
Warning!
• The lock nuts on all four feet must be screwed tightly against the
housing.
1.
Check if the legs are closely attached to the cabinet. If not,
please turn them to their original positions and tighten the nuts.
2.
Loosen the lock nut by turning the feet until they are in close
contacts with the floor.
3.
Adjust the legs and lock them with a spanner and make sure the
washing machine is steady.
Raise
Lower
Lock nut
Foot
Connecting the water supply hose
Warning!
• To prevent leakage or water damage, follow these instructions!
• Do not kink, crush, modify or sever the water inlet hose.
• For the model equipped with a hot valve, connect it to hot water
tap with hot water supply hose. Energy consumption will decrease
automatically for some programmes.
Connect the inlet pipe as indicated. There are two ways to connect
the inlet pipe.
1.
Connection between ordinary tap and inlet hose.
Clamp nut
Slide bushing
Loosen the clamp nut and tighten the clamp nut’s four bolts. Press
the slide bushing and then connection it by inserting the inlet hose
into the connecting base
2.
Connection between screw tap and inlet hose.
Slide bushing
Tap with threads and inlet hose Special tap for washing machine
Connect the other end of inlet pipe to the inlet valve at the back of the
washing machine and fasten the pipe tightly clockwise.
water inlet valve
water supply hose
