Kunft KDW5137 SL, Инструкция по эксплуатации

Страница: 10 / 33

18 19
KDW5137 WH
KDW5137 SL
EN
dishwasher
Starting a Washing Cycle
1. Draw out the lower and upper baskets, load the dishes and then
push them back. It is recommended to load the lower basket first,
then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. Please refer to the last page
“Product Data Sheet” for information on the power supply.
4. Make sure that the water supply is turned on to full pressure.
5. Close the door and press the POWER button to switch on the
machine.
6. Choose a programme, and the response light will turn on. Then
press the Start / Pause button and the dishwasher will start its
cycle.
Changing the Programme Mid-cycle
A cycle that is underway can only be modified if it still in the
beginning. Otherwise, the detergent may have already been
released and the dishwasher may have already drained the wash
water. If this is the case, the dishwasher needs to be reset and
the detergent dispenser must be refilled. To reset the dishwasher,
follow the instructions below:
1. Press the Start / Pause button for more than 3 seconds and the
machine will pause.
2. Rotate the knob to select the desired programme.
3. Press the Start / Pause button; after 10 seconds, the dishwasher
will start.
If you Forget to Add a Dish
A forgotten dish can be added any time before the detergent
dispenser opens. If this is the case, follow the instructions below:
1. Press the Start / Pause button to pause the washing.
2. Wait 5 seconds and then open the door.
3. Add the forgotten dishes.
4. Close the door.
5. Press the Start / Pause button; after 10 seconds the dishwasher
will start.
After 5 sec
WARNING
It is dangerous to open the door mid-cycle, as hot steam
may scald you.
2.3. Troubleshooting
ERROR CODES
If there is a malfunction, the dishwasher will display error codes to
identify these:
Codes Meanings Possible Causes
Rapid indicator
flashes frequently
Longer inlet time. Faucets are not open, or the
water intake is restricted, or
the water pressure is too low.
90 min and
Rapid indicators
flash frequently
Not reaching
required
temperature.
Malfunction of the heating
element .
Glass indicator
flashes frequently
Overflow. Some dishwasher element
is leaking.
WARNING
• If an overflow occurs, turn off the main water supply before calling
the Customer Support Service.
• If there is water in the base pan due to an overfill or small leak, the
water should be removed before restarting the dishwasher.