EN
WWW.BORMANNTOOLS.COM
5
Fuel Filter Service
Remove the spark plug.
Drain the fuel by tilting the engine.
Pull out the fuel filter and clean it gently.
Fuel tank cleaning
Remove the fuel filler cap.
Drain the fuel by tilting the engine.
Pull out the fuel filter and remove water and dirt stood in the fuel tank buy rinsing its inside.
Cooling Fin (Available on some models)
Check the cooling fin of its dirt through the fin cover.
Fuel Tube
Check the fuel tube and the fuel return tube of its deterioration.
Storage
Drain the fuel from the fuel tank.
Press the priming pump several times and drain the fuel from the fuel tank again.
Remove the oil filler cap and drain the oil.
Fill the oil to the edge of the oil filler neck.
Store the engine in a clean area.
Troubleshooting
The engine fails to Start
Check fuel from the outside of the fuel tank
check a fuel flow in the fuel return tube by pressing the priming pump several time.
Remove the spark plug.
If the engine still does not start, take the engine to your nearest service department.
Introduction
This outboard motor has been designed and is intended for the skippers of small boats (carrying capacity less than 4 people ),
powered by outboard motors and operating in near waters.
Operating the outboard motor
Our outboard motors are pure gasoline -driven, 4-stroke
1. Manual start recoil handle
2. Choke knob
3. Rod for adjusting trim angle
4. Throttle control & steering handle
5. Rope attachment
6. Emergency-stop (kill) switch, lock plate and lanyard
7. Shallow-water lever for raising motor
8. Tilt lock for preventing accidental
9. Propeller
