KUKEN 34179, Инструкция по эксплуатации

Страница: 29 / 71

29
EN
Problems Possible reasons Solutions
Clean Water Tank Indicator Display Is
Incorrect
• Not calibrated.
• Remove the clean water tank, then
start EasyClean and spray the spray,
turn EasyClean off until the pipe is
drained. Then press the “Switch Button”
and “Eco / Max Button” for 5 seconds
until the digital display flashes twice,
then check again.
The aspirate is weak • The Hepa is blocked.
• Please check and clean the Hepa.
• First dry the Hepa.
• Check and reinstall the scraper.
Clean water tank is leaking
• The volume of clean water is greater than
the valve.
• The clean water tank is not installed
properly.
• The cap is not screwed on properly.
• Pour in a little water until the volume
is below the valve.
• Reinstall the water tank.
• Screw the cap on tightly.
No water comes out when spraying
• The clean water tank is empty.
• The clean water tank is not installed
properly.
• Please fill the clean water from the
tank.
• Reinstall the water tank.
Without voice
• The voice switch is off.
• Your version excludes voice.
• Turn on the voice switch.
• Check and confirm with the local seller.
Self-cleaning mode does not work
• EasyClean does not connect to the power
supply.
• The dirty water tank is full.
• There is a shortage of clean water in the
tank.
• Check and connect the power supply
properly.
• Empty the dirty water tank.
• Fill the tank with clean water.
There are drops of water in the air
outlet
• The Hepa is not installed.
• EasyClean bent down hard.
• EasyClean sucked in the liquid foam.
• Check and install HEPA.
• Use the machine correctly.
• Empty the dirty water tank on time.
EasyClean shakes when used
• The brush roller is not installed
good.
• Check and reinstall the rotating brush
as a guide.
The flap "empty the water tank" is
always activated
• HEPA is blocked.
• The dirty water tank is full.
• Clean the HEPA.
• Empty the dirty water tank.
Codes of
mistake
Possible reasons Soluciones
FF:01 Overvoltage on load. Replace the adapter.
FF:02 Over current in load. Replace the adapter.
FF:03 NTC Open circuit / Short circuit. Replace the battery.
FF:04 Replace the battery. Replace the battery.