Kühtreiber MAKin 200 Multi MIG, Инструкция по эксплуатации

Страница: 24 / 32

24 |
Error Cause Solution
1
When the machine is turned on, the power-on
lamp is off, the fan is working.
the power-on lamp is damaged, incorrectly
connected.
replace the indicator lamp, check the wiring
circuit.
the power pcB is damaged. repair / replace the power pcB.
2
When the machine is turned on, the power-on
light is on, the fan is not working.
the fan is blocked by a foreign object. remove the object.
the fan motor is damaged. replace the fan.
3
the power-on lamp does not light when the
machine is turned on, the fan does not work.
No output voltage. check the network connection.
overvoltage in the network. check the network connection.
4 No output voltage at terminals. damaged power pcB. check the power section of the machine.
5 the arc cannot be ignited.
the welding cables are not
connected.
connect both welding cables.
the welding cables are damaged. repair / replace damaged cable.
the ground cable is not connected.
check the grounding cable
connection.
6 the arc is difficult to ignite.
Welding cables are incorrectly connected. check the connection.
the work clamps are covered with dirt. check and clean the work clamps.
7 unstable arc. arc power too low. increase the welding current.
8 the welding current cannot be set.
damaged control potentiometer or loose control
n-coder.
repair / replace potentiometer; pull the n-coder.
9 insufficient material penetration.
Welding current too low. set the correct welding current.
the arc is too small. increase the welding current.
10 the fault / overheat indicator is on.
overheating of the machine.
use interval welding.
operating/duty cycle was too long.
Wrong output voltage. check / replace the power section of the machine.
Error messages
Error Error code Description
temperature sensor
e01 sensor overheating 1
e02 sensor overheating 2
e03 sensor overheating 3
e04 sensor overheating 4
e09 machine overheating
Welding machine
e10 phase error
e11 Water cooling error
e12 protective gas error
e13 undervoltage in the network
e14 overvoltage in the network
e15 current overvoltage
e16 Wire feeder overload
Buttons
e20 control panel button error
e21 other control of panel error
e22 Welding torch error
e23 Welding torch error during welding process
accessories
e30 cutting torch disconnected
e31 Water cooling disconnected
communication
e40 problem of communication between feeder and source
e41 communication error
en