Kühtreiber MAKin 200 Multi MIG, Инструкция по эксплуатации

Страница: 21 / 32

| 21 en
MIG
VOLTAGE
WIRE SPEED
CURRENT
AIR
TEST
WIRE
FEED
inductance setting
miG/maG n-coder i
MIG/MAG - Setting the 2-STROKE function
the function indicates how the welding process is activated. When using this
mode, it is necessary to press the torch button during welding, which sends
a signal to activate the welding process. pressing the torch button starts the
welding process and activates the sequence of functions. to activate function,
press the control button one after the other.
MIG
VOLTAGE
WIRE SPEED
CURRENT
AIR
TEST
WIRE
FEED
control button 2t
miG/maG
MIG/MAG - Setting the 4-STROKE function
the function indicates how the welding process is activated. When using this
mode, it is necessary to press and release the torch button, which sends a
signal to activate the welding process. the pre Gas function is then activa -
ted, followed by soFt start and transition to welding power. to complete
the welding process, the torch button must be pressed and released again to
terminate the welding process and start the post Gas function. to activate
function, press the control button one after the other.
MIG
VOLTAGE
WIRE SPEED
CURRENT
AIR
TEST
WIRE
FEED
control button 4t
miG/maG
MIG/MAG - Setting the SPOT WELDING function
this function is designed for spot welding of materials and allows setting the
duration of the welding process. the function must be activated using the
control button.
MIG
VOLTAGE
WIRE SPEED
CURRENT
AIR
TEST
WIRE
FEED
miG/maG spot welding
MIG/MAG - Setting the SPOT length
press the FuNctioN button and rotate the n-coder i sequentially to set the
point length. the function value is corrected with control n-coder ii.
MIG
VOLTAGE
WIRE SPEED
CURRENT
AIR
TEST
WIRE
FEED
miG/maG n-coder i n-coder ii spot welding
MIG/MAG - Setting the GAP between points
press the FuNctioN button and rotate the n-coder i sequentially to set the
gap length. the function value is corrected with control n-coder ii.
MIG
VOLTAGE
WIRE SPEED
CURRENT
AIR
TEST
WIRE
FEED
miG/maG n-coder i n-coder ii spot welding
Welding in method TIG
Welding inverters allow tiG welding with touch-triggering. the tiG method
is very effective for welding stainless steel. Switch the machine to TIG mode.
1. connect the welding accessories. Welding torch on the pole (-), grounding
cable on the pole (+), connect the protective gas.
2. turn the inverter on by the main switch. set the welding method tiG and
set the welding parameters according to the above procedure.