KUHN SpeedRake SR108, Руководство оператора

Страница: 29 / 44

Instructions for work
SpeedRake
SR108 SR110 SR112
27

Turning at headlands
At a headland, use the tractor hydraulics to lift the rake
wheels from the ground (A), turn around, and then lower
the rake wheels back to the ground (B).

Setting rake arm angle
Change the rake wheel angle by rotating the turnbuckle
(1).
Making the turnbuckle longer will increase the rake arm
angle, making a narrower windrow and a wider raking
width.
Making the turnbuckle shorter will decrease the rake arm
angle, making a wider windrow and a narrower raking
width.
To change rake arm angle:
- Loosen the nuts on the turnbuckle (3).
- Rotate turnbuckle barrel (1) using pin (2) until arm is
at desired angle.
- Retighten the turnbuckle nuts (3).
To prevent damage to the rake, DO NOT make
a sharp turn around at the headlands with the
rake in the work position.
The tractor hydraulics must be set to "float"
mode during operation.
180°
A
B
Never adjust rake arm angle by sliding the
inner turnbuckle barrel inward or outward
and installing the pin in a different hole. The
number of holes exposed on the inner
turnbuckle should correspond to the number
of holes showing on the telescoping arm
when adjusting raking width.
3
2
1