- 11 -
The GMD 802 F is standard equipped with a road signalling kit (no 107 6110).
For the GMD 602 F - 702 F the road signalling kit is available on option (see page 32).
Install the road signalling kit as described below :
- Fix the 2 signalling shields (1) on the supports (2) on each side of the machine with 6 hexagonal screws (3) (M
10 x 20), 6 self-locking nuts (M 10) and 2 flat iron bars (4) as shown on photo 2 (red corners must be facing upwards
and outwards).
- Fit pilot lights (5) to the front side of the reflector boards (1) (see photo 2).
- Fit the left tail light (6) identified by its white (shown in grey on figure A) connector terminal marked “L” to
the rear side of the left reflector board (photo 3).
- Fit the right tail light (marked “R” on its black connector terminal) to the rear side of the right reflector board.
- Layout the wiring harness using photos 2, 3 and 4 as a guide.The wiring harness is fixed on the frame with 4 clamp
collars and self-adhesive collar holders (7) and onto the hydraulic hoses with 9 clamp collars (8) (length 140 mm)
(photos 2, 3 and 4). Make sure to thread the wiring harnesses through holes (O) (photos 2 and 3).
Plug the harness connectors to the corresponding pilot and tail lamp terminals .The locking tab (12) of the
female connector (13) must be fully engaged over the peg (14) of the male connector (15) (fig. A).
- Attach electric plug support (9) to the main frame with an original hexagon bolt (10) (photo 2).
NOTE :
- A 7 pin socket is required at the front of the tractor in order to switch on the signalling element lights.
- When parking the machine, place plug (11) in its support (9) on the frame (photo 3).
SIGNALLING ELEMENTS
A
2
4
3
