KUHN AXIS 20.1, Руководство оператора

Страница: 117 / 216

Maintenance and repair
105
C
AXIS
20.1
AXIS
20.1
C.2 Adjusting the metering slide
Check that the metering slides open evenly before every working season and
during the season if necessary.
Requirements:

The mechanics must be freely movable to check the metering slide setting.

The return spring is unhooked.

Hydraulic cylinder is unhooked.
Check (e.g. left side of solid fertiliser broadcaster):
2. Push the metering slide against the pin and lock it in this position by tightening
the adjustment screw.

The stop on the lower scale plate (metering scale) is positioned at scale
value 85. If the position is not correct, the scale must be reset.
n
WARNING
Danger of crushing and shearing!
Power-operated components (adjustment lever, metering slide)
may crush and shear when working on them.
Pay attention to the shear points of the metering outlet and slides
during all adjustment work.
 Turn off tractor. Remove the ignition key.
 Do not operate hydraulic slide actuators during adjustment
work.
1. Take a lower link pin d = 28
mm and insert it centrally into
the outlet.
Figure 26: Lower link pin in outlet