22
6. Remove the protec
�
ve plas
�
c cap from the cylinder valve.
7. Check that the hose does not contain kinks, that the cylinder does not have sharp edges, and does not contact surfaces that may become hot
during use.
8. Hold regulator and insert the brass nipple into the LP cylinder valve outlet. Ensure that the device is centered properly.
9. Turn the large coupling nut clockwise by hand and
�
ghten to a full stop. Take care to not cross thread the coupling nut onto the cylinder
valve. Do not use tools to
�
ghten connec
�
on.
Note: If you are unable to make the connec
�
on, repeat Step 7 and 8.
10.
Leak check all
fi�ngs
before ligh
�n
g your pizza oven. See sec
�o
n on Leak Tes
�
ng of this manual.
REGULATOR RESETTING PROCEDURE:
If your pizza oven will not get hot enough to cook, the
fl
ow limi
�
ng device may have been ac
�
vated.
Mini Reset:
Turn All burner control knobs to OFF , turn o
ff
the cylinder valve. Wait one minute. Slowly turn cylinder valve ON and relight pizza oven.
If burner
fl
ame is higher and pizza oven heats up properly proceed with cooking.
Full Rest:
Turn All burner control knobs to OFF , turn o
ff
the cylinder valve. Disconnect hose and regulator from cylinder. Wait two minutes,
re
a�
ach hose and regulator and perform leak test.
LEAK TESTING:
WARNING
DANGER
WHEN TO PERFORM A LEAK TEST:
A er assembling your pizza oven and before ligh
�
ng for the
fi
rst
�
me, even if purchased fully assembled.
Every me the LP gas cylinder is re lled, exchanged or if any of the gas components are disconnected or replaced.
Any me your pizza oven has been moved.
At least once per year or if your pizza oven has not been used for more than 60 days.
Never use your pizza oven without leak tes
�
ng all gas connec
�o
ns, hoses and propane tank. Follow the sec
�o
n on
‘Leak Tes
�
ng’ of this manual for proper procedures.
To prevent
fi
re or explosion hazard:
DO NOT smoke or permit igni
�on
sources in the area while conduc
�
ng a leak test.
Perform test OUTDOORS in a well ven
�
lated area that is protected from the wind.
Never perform a leak test with a match or open
flam
e.
Never perform a leak test while the pizza oven is in use or while pizza oven is s
�ll
hot.
FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE
WWW.KUCHT.COM
