Kubota Z231KW-AU, Руководство оператора

Страница: 49 / 76

4. Checking the tire pressure
WARNING
To avoid serious injury or death:
• Do not attempt to mount a tire on a rim. This
should be done by a qualified person with the
proper equipment.
• Always maintain the correct tire pressure.
The inflation pressure in the front tires rises
quickly when using compressed air.
Do not inflate the tires above the recommended
pressure shown in the operator's manual.
IMPORTANT :
• Do not use tires larger than specified.
4.1 Inflation pressure
Even though the inflation pressure is factory-set to the
prescribed level, it naturally drops slowly in the course
of time. Therefore, check it everyday and inflate as
necessary.
Tire sizes
Recommended inflation
pressure
Front 11 x 4 - 5, 4PR smooth
170 kPa
(1.7 kgf/cm
2
, 25 psi)
Rear 18 x 7.5 - 10, 4PR turf
83 kPa
(0.9 kgf/cm
2
, 12 psi)
(1) Ground (A) “INSUFFICIENT”
(B) “NORMAL”
(C) “EXCESSIVE”
5. Checking movable parts
If any of the movable parts, such as levers and pedals,
cannot be smoothly moved because of rust or anything
sticky, do not attempt to force it into motion.
In this case, remove the rust or the sticky object, and
apply oil or grease on the relevant spot. Otherwise, the
machine may get damaged.
EVERY 50 HOURS
1. Checking the engine start system
The engine start system in your machine is designed to
protect you while operating. Check the engine start
system periodically (daily is best) to test the function of
the engine start system before operation.
WARNING
To avoid serious injury or death:
• Do not allow anyone near the machine while
testing.
• If the machine does not pass one of the
following tests, do not operate the machine.
Consult your local KUBOTA Dealer.
• Sit on the operator's seat for all tests except for
test 1.
IMPORTANT :
• Test the following before operating the
machine:
(1) Parking brake lever
(2) Motion control lever
(3) Key switch
(4) PTO switch
(5) Seat switch
Test 1 (operator not on the seat)
1. Securely set the parking brake.
2. Set the PTO switch to the
“DISENGAGE” (OFF)
position.
3. Set the motion control levers to the “NEUTRAL
LOCK” position.
4. Turn the key switch to the “START” position.
5. The engine must not crank.
Test 2 (operator on the seat)
1. Do not set the parking brake (release it from test 1).
2. Set the PTO switch to the
“DISENGAGE” (OFF)
position.
3. Set the motion control levers to the “NEUTRAL
LOCK” position.
4. Turn the key switch to the “START” position.
5. The engine must not crank.
PERIODIC SERVICE DAILY CHECK
46
Z231KW-AU