Kubota XN12-8, Руководство по эксплуатации

Страница: 132 / 182

Maintenance
Every 250h
oil filter wrench: 19.6 to 23.5N·m).
10. Add lubricating oil between the upper limit
(H) and lower limit (L) of the oil dipstick
(1). If the oil level is too low or too high, it
will cause problems.
11. Tighten the fuel filler cap.
12. Start the engine, run it at a low idle speed
for 5 minutes and turn off the engine.
13. After about 10 minutes, check the oil level.
Cleaning of Air Filter
Warning
●
Please stop the engine and wait for the
machine to cool down before
maintenance.
• The engine, exhaust pipe, radiator, and
many other machine parts are really hot
when the engine is just stopped.
Touching them will cause scalding.
●
While using compressed air, please wear
necessary protection appliances,
including goggles and filtration mask, as
the metal fragments and other objects
will splash to cause accidents of serious
harms.
Important: Take cautions not to scratch the
filter element. Do not use any damaged filter
element.
Important: During the operations under dusty
environment, please daily fulfill the checking
and maintenance for the machine.
Important:
Ensure to steadily install the filter
element and dust cover. Otherwise, the ingress
of dusts into the cylinders will damage the
engine.
1. Open the engine hood.
2. Loosen the clamp (1) and take out the dust
collector (2).
3. Clean the inside of dust collector (2).
4. Take out the primary filter element (3).
5. Cover the inlet and outlet on the back of
5-31