Kubota WSM ZD1211, Руководство по ремонту

Страница: 19 / 31

GENERAL
ZD1211, ZD1211R, ZD1211L, ZD1211RL, WSM
G-2
2. GENERAL PRECAUTIONS
• When you disassemble, carefully put the parts in a clean area
to make it easy to find the parts. You must install the screws,
bolts and nuts in their initial position to prevent the reassembly
errors.
• When it is necessary to use special tools, use KUBOTA special
tools. Refer to the drawings when you make special tools that
you do not use frequently.
• Before you disassemble or repair machine, make sure that you
always disconnect the ground cable from the battery first.
• Remove oil and dirt from parts before you measure.
• Use only KUBOTA genuine parts for replacement to keep the
machine performance and to make sure of safety.
• You must replace the gaskets and O-rings when you assemble
again. Apply grease (1) to new O-rings or oil seals before you
assemble.
• When you assemble the external or internal circlips, make sure
that the sharp edge (3) faces against the direction from which
force (2) is applied.
• When inserting spring pins, their splits must face the direction
from which a force is applied. See the figure on the left side.
• To prevent damage to the hydraulic system, use only specified
fluid or equivalent.
WSM000001GEG0092US0
(1) Grease
(2) Force
(3) Sharp Edge
(4) Axial Force
(5) Rotating Movement
(A) External Circlip
(B) Internal Circlip
KiSC issued 06, 2017 A