Kubota U35-4, Руководство оператора

Страница: 31 / 120

9 CHECKS BEFORE START
C Fuel supply
The following functions are helpful when adding the fuel.
The fueling progress can be monitored by a buzzer sound.
Procedure
1. Press the user setting switch(switch 1) or the display
selector switch(switch 5) on the meter with the key
OFF. (Keep the key at OFF.)
2. Add fuel.
3. The buzzer sound interval changes according to the
amount fuel added. As the fuel amount becomes close
to full, the buzzer sound changes to continuous
beeping.
A
If the fuel is poured too fast, the buzzer may not sound
according to the fueling process.
A The moment when the fuel tank is nearly full, the
buzzer starts beeping.
A
Look into the fuel tank when pouring the fuel. Listen to
the buzzer sound for a rough estimate of the fill-up
progress.
C Coolant Temperature Gauge
To avoid personal injury or death:
A
Do not open the radiator cap during or just after
operation. Hot coolant may gush out and scald
you. Wait for the coolant to cool down before
opening the cap.
With the starter key at the " RUN " position, the coolant
temperature is indicated.
If the coolant temperature indicator is near " H ", take the
steps below.
Depending on the coolant temperature, the warning
message
"Water temp is rising" or "Overheat Engine
to idle for cooling" appears. In either case too, follow the
same procedure below.
1. Discontinue the job.
2. Reduce engine rpm's to idle and keep it at idle for 5
minutes.
3. Stop the engine and check the following points (1)-(4).
(1) Low coolant level or leak
(2) Fan belt tension
(3) Mud or dust deposits on radiator
(4) Hydraulic oil leak
(1) Coolant temperature gauge