Kubota M6H-101, Руководство оператора

Страница: 190 / 202

Oil separator fuse (if equipped)
Fuse No. Capacity Protected circuit
(1) 15 A Heater (oil separator, out 1)
(2) 15 A Heater (oil separator, in)
(3) 15 A Heater (oil separator, out 2)
5. Replacing slow-blow fuses
The slow-blow fuses are intended to protect the
electrical cabling. If any of them has blown out, be sure
to pinpoint the cause. Never use any substitute, use
only a KUBOTA genuine part.
Fuse No. Capacity Protected circuit Type
(1) 30 A Main key switch
Bolt fixed
(2)
100 A Charge
120 A
(option)
Charge
(3) 50 A Hazard
Non bolt fixed
(4) 60 A SCR system
(5) 120A Engine preheat
Bolt fixed
(6) 30A Work light
(7) 30A ---
Non bolt fixed
(8) 60A ---
6. Replacing light bulb
Headlight
• Take the bulb out of the light body and replace with
a new one.
Other lights
• Detach the lens and replace the bulb.
Light Capacity
Headlight 55 / 60 W
Hazard light 21 W
Rear turn signal 21 W
Tail light 5 W
Rear work light 35 W
Front work light 35 W
7. Replacing head lamp
CAUTION
To avoid personal injury:
• Be careful not to drop the bulb, hit anything
against the lamp, apply excess force, or get the
lamp scratched. If broken, glass may cause
injury. Pay more attention to halogen lamps in
particular, which have high pressure inside.
• Before replacing the lamp, be sure to turn off
the light and wait until the bulb cools down;
otherwise, you may get burned.
1. While pushing the right and left lock buttons, pull
and remove the electrical connector.
2. Remove the rubber boot.
3. Remove the clamping fixture and take out the bulb.
PERIODIC SERVICE SERVICE AS REQUIRED
184
M6S-111,M6L-111,M6H-101