Kubota M6H-101, Руководство оператора

Страница: 169 / 202

Proper toe-in = (A) - (B)
M6S-111 2WD 1 to 5 mm (0.04 to 0.2 in.)
M6S-111 4WD
M6L-111
M6H-101
2 to 8 mm (0.08 to 0.31 in.)
1. Park the tractor on a flat surface.
2. Turn the steering wheel so that the front wheels are
in the straight ahead position.
3. Lower the implement, lock the park brake and stop
the engine.
4. Measure the distance between the tire beads at the
front of the tire, at hub height.
5. Measure the distance between the tire beads at the
rear of the tire, at hub height.
6. The front distance should be shorter than the rear
distance. If not, adjust the tie rod length.
1.1 Adjusting toe-in procedure
1. Detach the snap ring.
2. Loosen the tie-rod nut.
3. Turn the tie-rod joint to adjust the rod length until
the proper toe-in measurement is obtained.
4. Retighten the tie-rod nut.
5. Attach the snap ring of the tie-rod joint.
M6S-111 2WD
(1) Snap ring (both sides, LH not shown in illustration)
(2) Tie-rod nut (both sides, LH not shown in illustration)
(167 to 196 N ⋅ m
17 to 20 kgf ⋅ m
123.2 to 144.6 ft ⋅ lbs
(3) Tie-rod joint (both sides, LH not shown in illustration)
M6S-111 4WD, M6L-111 and M6H-101
(1) Snap ring (both sides, LH not shown in illustration)
(2) Tie-rod nut (both sides, LH not shown in illustration)
(167 to 196 N ⋅ m
17 to 20 kgf ⋅ m
123.2 to 144.6 ft ⋅ lbs
(3) Tie-rod joint (both sides, LH not shown in illustration)
2. Draining fuel tank water
Loosen the drain plug at the bottom of the fuel tank to
let sediments, impurities and water out of the tank.
Finally, tighten up the plug.
M6S-111 and M6L-111
(1) Fuel tank (both sides, LH not shown in illustration)
(2) Drain plug
EVERY 200 HOURS PERIODIC SERVICE
M6S-111,M6L-111,M6H-101
163